Technysound TS 30/300
Thiele-Small parameters
| Nominal size | 12" |
|---|---|
| Impedance | 8 Ω |
| Fs | 48.6 Hz |
| Qts | 0.663 |
| Qes | 0.795 |
| Qms | 3.99 |
| Vas | 65 L |
| Sd | 490 cm² |
| Xmax | 4 mm |
| Re | 7.3 Ω |
| Bl | 12.5 T·m |
| Mms | 55.6 g |
| Pe | 150 W |
| Sensitivity | 92.1 dB |
Alignment hint
| EBP | 61 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 472.8 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Fane SOVEREIGN 12-200LT | 50 +1.4 | 0.655 -0.01 | 78.1 +13.1 | 5.3 +1.3 | 93.8 +1.7 | close | + | |
| Fane 12-250TC SOVEREIGN | 50 +1.4 | 0.658 -0.01 | 78.1 +13.1 | 3.5 -0.5 | 93.8 +1.7 | close | Xmax 3.5 mm < 4 mm: lower excursion-limited SPL | + |
| Fane SOVEREIGN 12-250TC | 50 +1.4 | 0.658 -0.01 | 78.1 +13.1 | 3.5 -0.5 | 93.8 +1.7 | close | Xmax 3.5 mm < 4 mm: lower excursion-limited SPL | + |
| Siare 31TE vp | 53.4 +4.8 | 0.746 +0.08 | 62 -3 | 4.1 +0.1 | 93.8 +1.7 | close | + | |
| Skytronic 902.436 | 42 -6.6 | 0.6 -0.06 | 65 = | 4 = | 89.8 -2.3 | close | + | |
| Faital PRO 12PR310 | 55 +6.4 | 0.67 +0.01 | 65.1 +0.1 | 4.92 +0.92 | 98 +5.9 | usable | 16 Ω vs 8 Ω: amp load changes | + |
| Fonestar FPW 350 | 52 +3.4 | 0.876 +0.21 | 65 = | 3.7 -0.3 | 91.8 -0.3 | usable | Xmax 3.7 mm < 4 mm: lower excursion-limited SPL | + |
| Pioneer TS-A30S4 | 39.2 -9.4 | 0.7 +0.04 | 56.1 -8.9 | 6.6 +2.6 | 92.1 = | usable | 4 Ω vs 8 Ω: amp load changes | + |
| Selenium 12SW10A DVC | 36 -12.6 | 0.665 = | 63.6 -1.4 | 7 +3 | 94.7 +2.6 | usable | 2 Ω vs 8 Ω: amp load changes | + |
| Faital PRO 12PR300-16 | 50 +1.4 | 0.494 -0.17 | 76.7 +11.7 | 4.9 +0.9 | 92.6 +0.5 | usable | 16 Ω vs 8 Ω: amp load changes | + |
Compare the closest 3 against the TS 30/300 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.