Sphynx SP-W10-SONO
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 8 Ω |
| Fs | 44 Hz |
| Qts | 0.809 |
| Qes | 0.89 |
| Qms | 8.93 |
| Vas | 72 L |
| Sd | 346 cm² |
| Xmax | 4 mm |
| Re | 7.91 Ω |
| Bl | 8.7 T·m |
| Mms | 30.5 g |
| Pe | 100 W |
| Sensitivity | 90.4 dB |
Alignment hint
| EBP | 49 · sealed |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP < 50: favours a sealed (closed) alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Sphynx SP-W250-PP | 43 -1 | 0.794 -0.02 | 65.8 -6.2 | 4 = | 90.1 -0.3 | close | + | |
| Europsonic HP20/150C | 45 +1 | 0.75 -0.06 | 75 +3 | 4.4 +0.4 | 90.3 -0.1 | close | 16 Ω vs 8 Ω: amp load changes · 75 W vs 100 W: lower power handling | + |
| Monacor SP-250PA v2017 | 48 +4 | 0.779 -0.03 | 72 = | 4.3 +0.3 | 91.7 +1.3 | close | + | |
| Hyper Phase BF10R | 45 +1 | 0.831 +0.02 | 78 +6 | 3.5 -0.5 | 90.8 +0.4 | close | 60 W vs 100 W: lower power handling · Xmax 3.5 mm < 4 mm: lower excursion-limited SPL | + |
| Kenford HW-1006 | 37 -7 | 0.787 -0.02 | 75 +3 | 4.7 +0.7 | 88.3 -2.1 | close | + | |
| JL Audio 10IB4 | 37.5 -6.5 | 0.771 -0.04 | 82.9 +10.9 | 7 +3 | 89.6 -0.8 | usable | + | |
| Europsonic TS25-180D | 34 -10 | 0.767 -0.04 | 73.5 +1.5 | 4 = | 87 -3.4 | usable | + | |
| Focal 27 F | 43.7 -0.3 | 0.82 +0.01 | 45.5 -26.5 | 5.8 +1.8 | 92.8 +2.4 | usable | 4 Ω vs 8 Ω: amp load changes | + |
| Goldwood GW-210/4 | 41.8 -2.2 | 1.067 +0.26 | 64.2 -7.8 | 3.5 -0.5 | 90.7 +0.3 | usable | 4 Ω vs 8 Ω: amp load changes · Xmax 3.5 mm < 4 mm: lower excursion-limited SPL | + |
| PAD 12.0033 vp | 40 -4 | 0.87 +0.06 | 53 -19 | 4 = | 86.9 -3.5 | usable | 16 Ω vs 8 Ω: amp load changes | + |
Compare the closest 3 against the SP-W10-SONO →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.