Scan-Speak 28W/8878T01
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 8 Ω |
| Fs | 22 Hz |
| Qts | 0.312 |
| Qes | 0.33 |
| Qms | 5.81 |
| Vas | 116 L |
| Sd | 363 cm² |
| Xmax | 7.5 mm |
| Re | 6.3 Ω |
| Bl | 14.8 T·m |
| Mms | 83.3 g |
| Pe | 200 W |
| Sensitivity | 88.7 dB |
Alignment hint
| EBP | 67 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 28 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Accuton AS250-8-552 v2018 | 22 = | 0.353 +0.04 | 119 +3 | 9 +1.5 | 87.6 -1.1 | close | + | |
| Volt SB2550 | 21 -1 | 0.288 -0.02 | 111 -5 | 10.4 +2.9 | 88 -0.7 | close | + | |
| Purifi Audio PTT10.0X04-NAB-01 | 20 -2 | 0.292 -0.02 | 113 -3 | 10.8 +3.3 | 89 +0.3 | close | + | |
| Peerless NE265W-08 | 23 +1 | 0.301 -0.01 | 97.2 -18.8 | 9.4 +1.9 | 88.9 +0.2 | close | + | |
| Vifa NE-265W-08 | 23 +1 | 0.301 -0.01 | 97.2 -18.8 | 9.4 +1.9 | 88.9 +0.2 | close | + | |
| Dayton Audio RS270P-8A | 22.9 +0.9 | 0.319 +0.01 | 110.5 -5.5 | 6 -1.5 | 87.7 -1 | close | 100 W vs 200 W: lower power handling · Xmax 6 mm < 7.5 mm: lower excursion-limited SPL | + |
| Peerless 831727 | 22.3 +0.3 | 0.332 +0.02 | 136.2 +20.2 | 9 +1.5 | 89.7 +1 | close | 110 W vs 200 W: lower power handling | + |
| Peerless XXLS-830951 | 21 -1 | 0.308 = | 103 -13 | 10.1 +2.6 | 91.6 +2.9 | close | 4 Ω vs 8 Ω: amp load changes | + |
| SB Acoustics SB29NRX75-6 | 21 -1 | 0.356 +0.04 | 102 -14 | 11 +3.5 | 88.7 = | close | + | |
| Peerless XXLS-835016 | 22.4 +0.4 | 0.315 = | 94.4 -21.6 | 7.1 -0.4 | 91.9 +3.2 | close | 4 Ω vs 8 Ω: amp load changes · 100 W vs 200 W: lower power handling · Xmax 7.1 mm < 7.5 mm: lower excursion-limited SPL | + |
Compare the closest 3 against the 28W/8878T01 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.