← all drivers

PRV Audio 10MR1000

10" · 8 Ω · 500 W · 95.4 dB · datasheet ↗

Thiele-Small parameters

Nominal size10"
Impedance8 Ω
Fs59.2 Hz
Qts0.323
Qes0.33
Qms14.71
Vas31 L
Sd363.1 cm²
Xmax5 mm
Re7.1 Ω
Bl18.6 T·m
Mms43.1 g
Pe500 W
Sensitivity95.4 dB

Alignment hint

EBP179 · ported
Sealed Vb (Qtc ≈ 0.71)≈ 8.2 L

EBP > 100: favours a ported (bass-reflex) alignment.

Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.

Substitute candidates

DriverFs (Hz)QtsVas (L)Xmax (mm)Sens (dB)FitNotesCompare
Beyma 10G4055 -4.20.314 -0.0133 +25 =95.4 =close+
Faital PRO 10PR33060 +0.80.33 +0.0132.5 +1.57.37 +2.3796 +0.6close300 W vs 500 W: lower power handling+
Faital PRO 10PR310 8 Ohms60 +0.80.339 +0.0228 -34.6 -0.495.9 +0.5close300 W vs 500 W: lower power handling · Xmax 4.6 mm < 5 mm: lower excursion-limited SPL+
Celestion NTR10-2520E56 -3.20.312 -0.0130 -14.75 -0.2593.7 -1.7close250 W vs 500 W: lower power handling · Xmax 4.75 mm < 5 mm: lower excursion-limited SPL+
Faital PRO 10PR31060 +0.80.34 +0.0232.2 +1.24.92 -0.0898 +2.6close300 W vs 500 W: lower power handling · Xmax 4.92 mm < 5 mm: lower excursion-limited SPL+
Faital PRO 10PR33060 +0.80.36 +0.0432.9 +1.97.27 +2.2795 -0.4close16 Ω vs 8 Ω: amp load changes · 300 W vs 500 W: lower power handling+
SB Audience BIANCO-10MW20058 -1.20.336 +0.0139.3 +8.35.2 +0.296.2 +0.8close+
Beyma 10LW30/N v201755 -4.20.29 -0.0328 -35.1 +0.195 -0.4close+
RCF MB 10N251 (prodance)58.9 -0.30.33 +0.0138.8 +7.84.8 -0.297.3 +1.9close300 W vs 500 W: lower power handling · Xmax 4.8 mm < 5 mm: lower excursion-limited SPL+
B&C 10NDL6458 -1.20.3 -0.0234.5 +3.54.5 -0.597 +1.6close16 Ω vs 8 Ω: amp load changes · 250 W vs 500 W: lower power handling · Xmax 4.5 mm < 5 mm: lower excursion-limited SPL+

Compare the closest 3 against the 10MR1000 →

Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.

Used in enclosures (0)

No enclosure in the catalog uses this driver yet.