Pioneer TS-SW2541D
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 4 Ω |
| Fs | 43.5 Hz |
| Qts | 0.95 |
| Qes | 1.04 |
| Qms | 11.3 |
| Vas | 8.25 L |
| Sd | 293 cm² |
| Xmax | 6 mm |
| Re | 3.6 Ω |
| Bl | 13.7 T·m |
| Mms | 197 g |
| Pe | 250 W |
| Sensitivity | 80 dB |
Alignment hint
| EBP | 42 · sealed |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP < 50: favours a sealed (closed) alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Pioneer TS-SW251 | 41.3 -2.2 | 1.09 +0.14 | 9.75 +1.5 | 6.6 +0.6 | 79.6 -0.4 | close | + | |
| Pioneer TS-SW2501S4 | 41.6 -1.9 | 0.93 -0.02 | 10.3 +2.05 | 3.6 -2.4 | 84.9 +4.9 | usable | Xmax 3.6 mm < 6 mm: lower excursion-limited SPL | + |
| Pioneer TS-W2501D4 | 38.8 -4.7 | 0.721 -0.23 | 6.3 -1.95 | 6 = | 82.7 +2.7 | usable | + | |
| Kenwood KFC-W2511 | 60 +16.5 | 0.84 -0.11 | 9.38 +1.13 | 7 +1 | 85.2 +5.2 | usable | + | |
| Pioneer TS-SW2502S4 | 42 -1.5 | 0.97 +0.02 | 18.5 +10.25 | 6.5 +0.5 | 83 +3 | usable | + | |
| JL Audio 10TW1-2 | 41.45 -2.05 | 0.65 -0.3 | 10.31 +2.06 | 10.31 +4.31 | 82.5 +2.5 | usable | 2 Ω vs 4 Ω: amp load changes | + |
| Focal 27 KX | 48 +4.5 | 0.908 -0.04 | 14.9 +6.65 | 4.5 -1.5 | 86.7 +6.7 | usable | 8 Ω vs 4 Ω: amp load changes · Xmax 4.5 mm < 6 mm: lower excursion-limited SPL | + |
| Xtant X2 1044 | 37.2 -6.3 | 0.961 +0.01 | 15.9 +7.65 | 5.7 -0.3 | 88.5 +8.5 | risky | 2 Ω vs 4 Ω: amp load changes · Xmax 5.7 mm < 6 mm: lower excursion-limited SPL | + |
| Pioneer TS-W2502D2 | 34.7 -8.8 | 0.659 -0.29 | 6.2 -2.05 | 6.3 +0.3 | 85 +5 | risky | 2 Ω vs 4 Ω: amp load changes | + |
| Skar Audio EV-10 S4 | 50.9 +7.4 | 0.76 -0.19 | 14 +5.75 | 8.5 +2.5 | 85.2 +5.2 | risky | 150 W vs 250 W: lower power handling | + |
Compare the closest 3 against the TS-SW2541D →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.