Pioneer TS-SW251
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 4 Ω |
| Fs | 41.3 Hz |
| Qts | 1.09 |
| Qes | 1.15 |
| Qms | 9.9 |
| Vas | 9.75 L |
| Sd | 309 cm² |
| Xmax | 6.6 mm |
| Re | 3 Ω |
| Bl | 11.8 T·m |
| Mms | 206.6 g |
| Pe | 200 W |
| Sensitivity | 79.6 dB |
Alignment hint
| EBP | 36 · sealed |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP < 50: favours a sealed (closed) alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Pioneer TS-SW2541D | 43.5 +2.2 | 0.95 -0.14 | 8.25 -1.5 | 6 -0.6 | 80 +0.4 | usable | Xmax 6 mm < 6.6 mm: lower excursion-limited SPL | + |
| Pioneer TS-SW2502S4 | 42 +0.7 | 0.97 -0.12 | 18.5 +8.75 | 6.5 -0.1 | 83 +3.4 | usable | Xmax 6.5 mm < 6.6 mm: lower excursion-limited SPL | + |
| Pioneer TS-SW2501S4 | 41.6 +0.3 | 0.93 -0.16 | 10.3 +0.55 | 3.6 -3 | 84.9 +5.3 | usable | Xmax 3.6 mm < 6.6 mm: lower excursion-limited SPL | + |
| JL Audio 10TW1-2 | 41.45 +0.15 | 0.65 -0.44 | 10.31 +0.56 | 10.31 +3.71 | 82.5 +2.9 | usable | 2 Ω vs 4 Ω: amp load changes | + |
| Kenwood KFC-W2511 | 60 +18.7 | 0.84 -0.25 | 9.38 -0.37 | 7 +0.4 | 85.2 +5.6 | usable | + | |
| Pioneer TS-W2501D4 | 38.8 -2.5 | 0.721 -0.37 | 6.3 -3.45 | 6 -0.6 | 82.7 +3.1 | usable | Xmax 6 mm < 6.6 mm: lower excursion-limited SPL | + |
| Xtant X2 1044 | 37.2 -4.1 | 0.961 -0.13 | 15.9 +6.15 | 5.7 -0.9 | 88.5 +8.9 | risky | 2 Ω vs 4 Ω: amp load changes · Xmax 5.7 mm < 6.6 mm: lower excursion-limited SPL | + |
| Pioneer TS-W261D4 | 46 +4.7 | 1.044 -0.05 | 17.7 +7.95 | 8.4 +1.8 | 89.9 +10.3 | risky | + | |
| JL Audio 10TW1-4 | 38 -3.3 | 0.6 -0.49 | 12.15 +2.4 | 10 +3.4 | 82.2 +2.6 | risky | + | |
| Skar Audio EV-10 S4 | 50.9 +9.6 | 0.76 -0.33 | 14 +4.25 | 8.5 +1.9 | 85.2 +5.6 | risky | 150 W vs 200 W: lower power handling | + |
Compare the closest 3 against the TS-SW251 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.