← all drivers

P.Audio BM-12W

12" · 4 Ω · 400 W · 92.9 dB

Thiele-Small parameters

Nominal size12"
Impedance4 Ω
Fs38 Hz
Qts0.335
Qes0.386
Qms2.5
Vas90.27 L
Sd509 cm²
Xmax4.5 mm
Re3.4 Ω
Bl12.3 T·m
Mms71.4 g
Pe400 W
Sensitivity92.9 dB

Alignment hint

EBP98 · flexible
Sealed Vb (Qtc ≈ 0.71)≈ 26.1 L

EBP 50-100: works in either a sealed or ported alignment.

Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.

Substitute candidates

DriverFs (Hz)QtsVas (L)Xmax (mm)Sens (dB)FitNotesCompare
Ciare HSB322 4-436 -20.363 +0.0383 -7.275.4 +0.993 +0.1close8 Ω vs 4 Ω: amp load changes · 200 W vs 400 W: lower power handling+
Audax PR330M0 vp137.7 -0.30.326 -0.0195.9 +5.634 -0.595 +2.1close8 Ω vs 4 Ω: amp load changes · 150 W vs 400 W: lower power handling · Xmax 4 mm < 4.5 mm: lower excursion-limited SPL+
Kartesian WOM300_vDIY37 -10.362 +0.0391.7 +1.436.4 +1.994.6 +1.7close8 Ω vs 4 Ω: amp load changes · 250 W vs 400 W: lower power handling+
Beyma SM112/W42 +40.335 =90 -0.275.5 +196.1 +3.2close8 Ω vs 4 Ω: amp load changes · 250 W vs 400 W: lower power handling+
JBL 2204J45 +70.35 +0.0187.8 -2.475.6 +1.192.7 -0.2close16 Ω vs 4 Ω: amp load changes+
Eminence OMEGA PRO 1239 +10.308 -0.0388.4 -1.874.8 +0.396 +3.1close8 Ω vs 4 Ω: amp load changes+
Volt RV3143 v201435 -30.302 -0.0386 -4.275.2 +0.793.8 +0.9close8 Ω vs 4 Ω: amp load changes · 300 W vs 400 W: lower power handling+
Beyma 12BR70 v235 -30.355 +0.02100 +9.734.1 -0.493.4 +0.5close8 Ω vs 4 Ω: amp load changes · 125 W vs 400 W: lower power handling · Xmax 4.1 mm < 4.5 mm: lower excursion-limited SPL+
MCM Electronics 55-295238 =0.338 =108 +17.733.8 -0.794.3 +1.4close8 Ω vs 4 Ω: amp load changes · 175 W vs 400 W: lower power handling · Xmax 3.8 mm < 4.5 mm: lower excursion-limited SPL+
Focal 13 WX33.6 -4.40.366 +0.0389 -1.276 +1.592.1 -0.8close8 Ω vs 4 Ω: amp load changes+

Compare the closest 3 against the BM-12W →

Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.

Used in enclosures (0)

No enclosure in the catalog uses this driver yet.