Monacor SPH-300CTC
Thiele-Small parameters
| Nominal size | 12" |
|---|---|
| Impedance | 4 Ω |
| Fs | 18 Hz |
| Qts | 0.185 |
| Qes | 0.19 |
| Qms | 6.5 |
| Vas | 225 L |
| Sd | 495 cm² |
| Xmax | 5.4 mm |
| Re | 3 Ω |
| Bl | 14.6 T·m |
| Mms | 119.3 g |
| Pe | 150 W |
| Sensitivity | 94.6 dB |
Alignment hint
| EBP | 95 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 16.5 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Focal AUDIOM 12VX | 23.5 +5.5 | 0.202 +0.02 | 238 +13 | 6 +0.6 | 94.5 -0.1 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| Peerless XXLS12-4 | 17.7 -0.3 | 0.195 +0.01 | 156.5 -68.5 | 7.8 +2.4 | 92.9 -1.7 | usable | + | |
| Klipsch K31 | 19 +1 | 0.185 = | 386 +161 | 5 -0.4 | 94.8 +0.2 | usable | 8 Ω vs 4 Ω: amp load changes · Xmax 5 mm < 5.4 mm: lower excursion-limited SPL | + |
| JBL 128-H vp ca1 | 21.2 +3.2 | 0.233 +0.05 | 222.7 -2.3 | 7.8 +2.4 | 93.1 -1.5 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| JBL 2214H | 23 +5 | 0.244 +0.06 | 223.7 -1.3 | 6.6 +1.2 | 93.9 -0.7 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| JBL 128-H vp ca2 | 21.6 +3.6 | 0.24 +0.05 | 214.6 -10.4 | 7.7 +2.3 | 93.1 -1.5 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| SEAS 33F-WKA | 22 +4 | 0.209 +0.02 | 310 +85 | 5 -0.4 | 95 +0.4 | usable | 8 Ω vs 4 Ω: amp load changes · 70 W vs 150 W: lower power handling · Xmax 5 mm < 5.4 mm: lower excursion-limited SPL | + |
| Eminence W1238R | 21.5 +3.5 | 0.252 +0.07 | 236.6 +11.6 | 8.2 +2.8 | 93.6 -1 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| Phase Linear ALIANTE 12 LTD | 19 +1 | 0.214 +0.03 | 151 -74 | 8 +2.6 | 92.6 -2 | usable | + | |
| Peerless XLS12 | 18.1 +0.1 | 0.199 +0.01 | 139.2 -85.8 | 9.5 +4.1 | 91.5 -3.1 | usable | + |
Compare the closest 3 against the SPH-300CTC →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.