Monacor SP-250C
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 4 Ω |
| Fs | 35 Hz |
| Qts | 0.409 |
| Qes | 0.47 |
| Qms | 3.15 |
| Vas | 96 L |
| Sd | 353 cm² |
| Xmax | 5 mm |
| Re | 3.7 Ω |
| Bl | 8.1 T·m |
| Mms | 37.6 g |
| Pe | 100 W |
| Sensitivity | 94.8 dB |
Alignment hint
| EBP | 74 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 48.3 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Carpower SP-252C | 35 = | 0.409 = | 96 = | 5 = | 94.8 = | close | + | |
| Eminence LEGEND BP102 | 35 = | 0.432 +0.02 | 91.2 -4.8 | 6.2 +1.2 | 92.7 -2.1 | close | 8 Ω vs 4 Ω: amp load changes | + |
| Eminence LEGEND BP102 4 Ohms | 34.5 -0.5 | 0.385 -0.02 | 103.8 +7.8 | 6.2 +1.2 | 97 +2.2 | close | + | |
| Davis 25GC10R | 37.2 +2.2 | 0.397 -0.01 | 80.9 -15.1 | 5.7 +0.7 | 93.5 -1.3 | close | 8 Ω vs 4 Ω: amp load changes | + |
| JBL LE10A | 30 -5 | 0.41 = | 101.9 +5.9 | 6.1 +1.1 | 92.5 -2.3 | close | 8 Ω vs 4 Ω: amp load changes · 60 W vs 100 W: lower power handling | + |
| Volt B250 | 31.7 -3.3 | 0.377 -0.03 | 104 +8 | 6 +1 | 92.8 -2 | close | 8 Ω vs 4 Ω: amp load changes | + |
| Davis 25SCA10T | 41 +6 | 0.449 +0.04 | 91.3 -4.7 | 4.8 -0.2 | 93.4 -1.4 | close | 8 Ω vs 4 Ω: amp load changes · 60 W vs 100 W: lower power handling · Xmax 4.8 mm < 5 mm: lower excursion-limited SPL | + |
| SICA Z005780 | 31.7 -3.3 | 0.455 +0.05 | 92.6 -3.4 | 8.9 +3.9 | 93.5 -1.3 | close | + | |
| Focal 10V 6411 | 32.9 -2.1 | 0.378 -0.03 | 116.9 +20.9 | 7 +2 | 93.4 -1.4 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| HiVi W10 | 35 = | 0.368 -0.04 | 81.4 -14.6 | 6.2 +1.2 | 91.8 -3 | usable | 8 Ω vs 4 Ω: amp load changes | + |
Compare the closest 3 against the SP-250C →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.