Klipsch K28E
Thiele-Small parameters
| Nominal size | 12" |
|---|---|
| Impedance | 4 Ω |
| Fs | 35.1 Hz |
| Qts | 0.441 |
| Qes | 0.63 |
| Qms | 1.47 |
| Vas | 152.7 L |
| Sd | 613 cm² |
| Xmax | 4 mm |
| Re | 3 Ω |
| Bl | 8.6 T·m |
| Mms | 70.8 g |
| Pe | 100 W |
| Sensitivity | 96.5 dB |
Alignment hint
| EBP | 56 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 97.2 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Davis KIT ALBEDO | 37.5 +2.4 | 0.459 +0.02 | 166 +13.3 | 5 +1 | 96.5 = | close | 8 Ω vs 4 Ω: amp load changes | + |
| Supravox 285 GMF vp5 | 35 -0.1 | 0.372 -0.07 | 150 -2.7 | 4 = | 95.4 -1.1 | close | 8 Ω vs 4 Ω: amp load changes · 70 W vs 100 W: lower power handling | + |
| Supravox 285 GMF vp6 | 35 -0.1 | 0.372 -0.07 | 150 -2.7 | 4 = | 95.4 -1.1 | close | 8 Ω vs 4 Ω: amp load changes · 70 W vs 100 W: lower power handling | + |
| Eminence DELTALITE II 2512 v2 | 37 +1.9 | 0.386 -0.05 | 147 -5.7 | 4.9 +0.9 | 96.3 -0.2 | close | 8 Ω vs 4 Ω: amp load changes | + |
| LaVoce LBASS12-15 | 38 +2.9 | 0.48 +0.04 | 160.93 +8.23 | 4.7 +0.7 | 95.5 -1 | close | 8 Ω vs 4 Ω: amp load changes | + |
| Monacor SP-300PA | 40 +4.9 | 0.435 -0.01 | 150 -2.7 | 3.3 -0.7 | 95.3 -1.2 | close | 8 Ω vs 4 Ω: amp load changes · Xmax 3.3 mm < 4 mm: lower excursion-limited SPL | + |
| Infinity 1211W | 35.1 = | 0.397 -0.04 | 123.3 -29.4 | 4.5 +0.5 | 97 +0.5 | close | + | |
| Visaton BZ300 4 Ohms | 36 +0.9 | 0.483 +0.04 | 129 -23.7 | 5 +1 | 95.7 -0.8 | close | + | |
| Faital PRO 12FE330 | 33 -2.1 | 0.45 +0.01 | 146.7 -6 | 8.32 +4.32 | 94 -2.5 | close | 8 Ω vs 4 Ω: amp load changes | + |
| Ardan PRO W-31 | 36.4 +1.3 | 0.382 -0.06 | 170.6 +17.9 | 4 = | 95.3 -1.2 | close | 8 Ω vs 4 Ω: amp load changes | + |
Compare the closest 3 against the K28E →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.