Kenford HW-1206
Thiele-Small parameters
| Nominal size | 12" |
|---|---|
| Impedance | 8 Ω |
| Fs | 31 Hz |
| Qts | 0.8 |
| Qes | 1 |
| Qms | 4 |
| Vas | 170 L |
| Sd | 520 cm² |
| Xmax | 3 mm |
| Re | 7.1 Ω |
| Bl | 9 T·m |
| Mms | 58.8 g |
| Pe | 100 W |
| Sensitivity | 89.5 dB |
Alignment hint
| EBP | 31 · sealed |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP < 50: favours a sealed (closed) alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Jamo 20325 | 32 +1 | 0.849 +0.05 | 163.4 -6.6 | 5 +2 | 93 +3.5 | close | 4 Ω vs 8 Ω: amp load changes | + |
| EMS LB12EX_06V | 34 +3 | 0.722 -0.08 | 200 +30 | 3 = | 90.2 +0.7 | close | 16 Ω vs 8 Ω: amp load changes · 40 W vs 100 W: lower power handling | + |
| Samy Speaker LW1200 v1 | 27.1 -3.9 | 0.754 -0.05 | 159.6 -10.4 | 4.5 +1.5 | 87 -2.5 | usable | 16 Ω vs 8 Ω: amp load changes | + |
| Kenwood RD 30 FU 120-F | 31.6 +0.6 | 0.879 +0.08 | 206.3 +36.3 | 8 +5 | 89.8 +0.3 | usable | + | |
| Pioneer PAX30G vp1 | 36.4 +5.4 | 0.816 +0.02 | 122.3 -47.7 | 3 = | 87.8 -1.7 | usable | 16 Ω vs 8 Ω: amp load changes · 60 W vs 100 W: lower power handling | + |
| ERS HP30/100 07172 | 30 -1 | 0.588 -0.21 | 176.8 +6.8 | 2.8 -0.2 | 91.2 +1.7 | usable | Xmax 2.8 mm < 3 mm: lower excursion-limited SPL | + |
| Sony XS-NW1201 | 27.5 -3.5 | 0.928 +0.13 | 151.21 -18.79 | 4.15 +1.15 | 86.7 -2.8 | usable | 4 Ω vs 8 Ω: amp load changes | + |
| Cabasse 30BZ18 v2 | 38.5 +7.5 | 0.747 -0.05 | 154.7 -15.3 | 4 +1 | 92.8 +3.3 | usable | + | |
| Sphynx SP-W310PP | 33 +2 | 0.618 -0.18 | 182.8 +12.8 | 5 +2 | 91 +1.5 | usable | 16 Ω vs 8 Ω: amp load changes | + |
| STX W.30.200.8.MC | 31 = | 0.622 -0.18 | 148 -22 | 6.2 +3.2 | 91.3 +1.8 | usable | + |
Compare the closest 3 against the HW-1206 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.