JBL GT5-10
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 8 Ω |
| Fs | 30 Hz |
| Qts | 0.498 |
| Qes | 0.54 |
| Qms | 6.48 |
| Vas | 31.5 L |
| Sd | 363 cm² |
| Xmax | 6.7 mm |
| Re | 4 Ω |
| Bl | 15.2 T·m |
| Mms | 165 g |
| Pe | 250 W |
| Sensitivity | 87 dB |
Alignment hint
| EBP | 56 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 31 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Wavecor SW275BD01 | 30.8 +0.8 | 0.564 +0.07 | 31 -0.5 | 6.9 +0.2 | 87.2 +0.2 | close | 4 Ω vs 8 Ω: amp load changes · 180 W vs 250 W: lower power handling | + |
| MTX Audio RT10-04 | 32 +2 | 0.49 -0.01 | 32.6 +1.1 | 6.7 = | 89.1 +2.1 | close | 4 Ω vs 8 Ω: amp load changes | + |
| Focal P25F | 31 +1 | 0.458 -0.04 | 29 -2.5 | 6.9 +0.2 | 87.6 +0.6 | close | 4 Ω vs 8 Ω: amp load changes | + |
| JBL GTO 1014D | 29.7 -0.3 | 0.439 -0.06 | 30.2 -1.3 | 7.3 +0.6 | 87.6 +0.6 | close | 4 Ω vs 8 Ω: amp load changes | + |
| MTX Audio T610-44 | 28.4 -1.6 | 0.484 -0.01 | 31.7 +0.2 | 7.8 +1.1 | 84.1 -2.9 | close | + | |
| Wavecor SW263TU01 | 29.5 -0.5 | 0.5 = | 24.5 -7 | 6.4 -0.3 | 86.8 -0.2 | close | 4 Ω vs 8 Ω: amp load changes · Xmax 6.4 mm < 6.7 mm: lower excursion-limited SPL | + |
| JBL GTO 1014 | 28.7 -1.3 | 0.456 -0.04 | 29.2 -2.3 | 7.3 +0.6 | 87.8 +0.8 | close | 4 Ω vs 8 Ω: amp load changes | + |
| Infinity KAPPA PERFECT 10 | 28.4 -1.6 | 0.419 -0.08 | 32.1 +0.6 | 7.1 +0.4 | 87.1 +0.1 | close | + | |
| JL Audio 10W3V3-2 | 33 +3 | 0.495 = | 32.17 +0.67 | 14 +7.3 | 85.37 -1.63 | close | 2 Ω vs 8 Ω: amp load changes | + |
| Polk Audio DX10-4 | 28.7 -1.3 | 0.49 -0.01 | 33.4 +1.9 | 8.7 +2 | 83.6 -3.4 | close | 4 Ω vs 8 Ω: amp load changes | + |
Compare the closest 3 against the GT5-10 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.