Goldwood GW-1038
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 8 Ω |
| Fs | 33.7 Hz |
| Qts | 1.1 |
| Qes | 1.5 |
| Qms | 4.4 |
| Vas | 90.299 L |
| Sd | 355 cm² |
| Xmax | 2.5 mm |
| Re | 7.2 Ω |
| Bl | 6.8 T·m |
| Mms | 43.792 g |
| Pe | 130 W |
| Sensitivity | 85.5 dB |
Alignment hint
| EBP | 22 · sealed |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP < 50: favours a sealed (closed) alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Europsonic HPC25/60 | 33.7 = | 1.217 +0.12 | 106.4 +16.1 | 2.9 +0.4 | 86.6 +1.1 | close | 30 W vs 130 W: lower power handling | + |
| Boss Audio CX10 | 36 +2.3 | 1.193 +0.09 | 75.9 -14.4 | 4 +1.5 | 85.9 +0.4 | close | 4 Ω vs 8 Ω: amp load changes | + |
| Visaton WS25 E 8 Ohms | 40 +6.3 | 0.995 -0.11 | 90 -0.3 | 4.6 +2.1 | 89 +3.5 | usable | 80 W vs 130 W: lower power handling | + |
| Visaton WS25 E | 34 +0.3 | 1.435 +0.34 | 113 +22.7 | 3.6 +1.1 | 85.1 -0.4 | usable | 80 W vs 130 W: lower power handling | + |
| Goldwood GW-1034 | 34.3 +0.6 | 0.881 -0.22 | 81.4 -8.9 | 2.5 = | 90.3 +4.8 | usable | 4 Ω vs 8 Ω: amp load changes | + |
| Europsonic HP25-180 | 34 +0.3 | 0.777 -0.32 | 86.3 -4 | 3 +0.5 | 89.3 +3.8 | usable | 90 W vs 130 W: lower power handling | + |
| Jamo 22320 | 35 +1.3 | 1.059 -0.04 | 122.6 +32.3 | 4 +1.5 | 92.1 +6.6 | usable | 4 Ω vs 8 Ω: amp load changes · 80 W vs 130 W: lower power handling | + |
| Davis 28MP10 | 40 +6.3 | 1.42 +0.32 | 80.1 -10.2 | 3 +0.5 | 87.8 +2.3 | usable | 60 W vs 130 W: lower power handling | + |
| Europsonic TS25-180D | 34 +0.3 | 0.767 -0.33 | 73.5 -16.8 | 4 +1.5 | 87 +1.5 | usable | 90 W vs 130 W: lower power handling | + |
| Goldwood GW-210/4 | 41.8 +8.1 | 1.067 -0.03 | 64.2 -26.1 | 3.5 +1 | 90.7 +5.2 | usable | 4 Ω vs 8 Ω: amp load changes | + |
Compare the closest 3 against the GW-1038 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.