Goldwood GW-1034
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 4 Ω |
| Fs | 34.3 Hz |
| Qts | 0.881 |
| Qes | 1.102 |
| Qms | 4.386 |
| Vas | 81.4 L |
| Sd | 355.4 cm² |
| Xmax | 2.5 mm |
| Re | 3.5 Ω |
| Bl | 5.7 T·m |
| Mms | 46.8 g |
| Pe | 130 W |
| Sensitivity | 90.3 dB |
Alignment hint
| EBP | 31 · sealed |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP < 50: favours a sealed (closed) alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Europsonic HP25-180 | 34 -0.3 | 0.777 -0.1 | 86.3 +4.9 | 3 +0.5 | 89.3 -1 | close | 8 Ω vs 4 Ω: amp load changes · 90 W vs 130 W: lower power handling | + |
| Hyper Phase BF10R | 45 +10.7 | 0.831 -0.05 | 78 -3.4 | 3.5 +1 | 90.8 +0.5 | usable | 8 Ω vs 4 Ω: amp load changes · 60 W vs 130 W: lower power handling | + |
| JL Audio 10IB4 | 37.5 +3.2 | 0.771 -0.11 | 82.9 +1.5 | 7 +4.5 | 89.6 -0.7 | usable | 8 Ω vs 4 Ω: amp load changes · 100 W vs 130 W: lower power handling | + |
| Kenford HW-1006 | 37 +2.7 | 0.787 -0.09 | 75 -6.4 | 4.7 +2.2 | 88.3 -2 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| Europsonic TS25-180D | 34 -0.3 | 0.767 -0.11 | 73.5 -7.9 | 4 +1.5 | 87 -3.3 | usable | 8 Ω vs 4 Ω: amp load changes · 90 W vs 130 W: lower power handling | + |
| Sphynx SP-W10-SONO | 44 +9.7 | 0.809 -0.07 | 72 -9.4 | 4 +1.5 | 90.4 +0.1 | usable | 8 Ω vs 4 Ω: amp load changes · 100 W vs 130 W: lower power handling | + |
| Visaton WS27AW | 38 +3.7 | 0.902 +0.02 | 105 +23.6 | 7.7 +5.2 | 89.7 -0.6 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| Visaton W250NG | 37 +2.7 | 0.876 -0.01 | 120 +38.6 | 6.1 +3.6 | 90.2 -0.1 | usable | 8 Ω vs 4 Ω: amp load changes · 80 W vs 130 W: lower power handling | + |
| Visaton WS25 E 8 Ohms | 40 +5.7 | 0.995 +0.11 | 90 +8.6 | 4.6 +2.1 | 89 -1.3 | usable | 8 Ω vs 4 Ω: amp load changes · 80 W vs 130 W: lower power handling | + |
| Goldwood GW-1038 | 33.7 -0.6 | 1.1 +0.22 | 90.299 +8.9 | 2.5 = | 85.5 -4.8 | usable | 8 Ω vs 4 Ω: amp load changes | + |
Compare the closest 3 against the GW-1034 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.