Focal AUDIOM 13KX
Thiele-Small parameters
| Nominal size | 12" |
|---|---|
| Impedance | 8 Ω |
| Fs | 28.8 Hz |
| Qts | 0.328 |
| Qes | 0.37 |
| Qms | 2.9 |
| Vas | 127 L |
| Sd | 530.9 cm² |
| Xmax | 6 mm |
| Re | 6.1 Ω |
| Bl | 16.8 T·m |
| Mms | 95 g |
| Pe | 225 W |
| Sensitivity | 92.3 dB |
Alignment hint
| EBP | 78 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 34.8 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Visaton TIW300 vp | 28.9 +0.1 | 0.32 -0.01 | 125 -2 | 8.3 +2.3 | 92.5 +0.2 | close | + | |
| Eton 12-612-C8/62RP | 28 -0.8 | 0.319 -0.01 | 134 +7 | 6.3 +0.3 | 92.5 +0.2 | close | 150 W vs 225 W: lower power handling | + |
| Fountek FW300B | 28.3 -0.5 | 0.306 -0.02 | 127.2 +0.2 | 6 = | 91.4 -0.9 | close | + | |
| Focal 13 VX | 30 +1.2 | 0.323 -0.01 | 117 -10 | 6.8 +0.8 | 92.5 +0.2 | close | + | |
| Eton 12-612/C8/62 RP | 30 +1.2 | 0.32 -0.01 | 134 +7 | 8.5 +2.5 | 92.1 -0.2 | close | 150 W vs 225 W: lower power handling | + |
| Dayton Audio ST305-8 | 29.6 +0.8 | 0.348 +0.02 | 128.1 +1.1 | 8 +2 | 92.9 +0.6 | close | + | |
| Dali A-12WD vp | 27 -1.8 | 0.328 = | 121 -6 | 8.8 +2.8 | 93.3 +1 | close | + | |
| SICA 12 SR 3 PL vp | 28.7 -0.1 | 0.317 -0.01 | 101.2 -25.8 | 7 +1 | 92.4 +0.1 | close | + | |
| Dayton Audio SD315-88 | 26.9 -1.9 | 0.342 +0.01 | 122.8 -4.2 | 5.5 -0.5 | 94.2 +1.9 | close | 4 Ω vs 8 Ω: amp load changes · 120 W vs 225 W: lower power handling · Xmax 5.5 mm < 6 mm: lower excursion-limited SPL | + |
| JBL LE14A | 28 -0.8 | 0.323 -0.01 | 147.3 +20.3 | 5.1 -0.9 | 92.8 +0.5 | close | 150 W vs 225 W: lower power handling · Xmax 5.1 mm < 6 mm: lower excursion-limited SPL | + |
Compare the closest 3 against the AUDIOM 13KX →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.