← all drivers

Faital PRO 15FH500

15" · 16 Ω · 500 W · 97 dB · datasheet ↗

Thiele-Small parameters

Nominal size15"
Impedance16 Ω
Fs35 Hz
Qts0.45
Qes0.47
Qms13.2
Vas217.1 L
Sd847 cm²
Xmax9.25 mm
Re12.7 Ω
Mms95.4 g
Pe500 W
Sensitivity97 dB

Alignment hint

EBP74 · flexible
Sealed Vb (Qtc ≈ 0.71)≈ 147.8 L

EBP 50-100: works in either a sealed or ported alignment.

Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.

Substitute candidates

DriverFs (Hz)QtsVas (L)Xmax (mm)Sens (dB)FitNotesCompare
Faital PRO 15FH500A35 =0.394 -0.06217.4 +0.39 -0.2597.1 +0.1close8 Ω vs 16 Ω: amp load changes · Xmax 9 mm < 9.25 mm: lower excursion-limited SPL+
Eminence Kl3015CX-8 vp38 +30.438 -0.01219.7 +2.67.8 -1.4597.5 +0.5close8 Ω vs 16 Ω: amp load changes · Xmax 7.8 mm < 9.25 mm: lower excursion-limited SPL+
Faital PRO 15FH500 16 Ohms35 =0.454 =196.8 -20.39.3 +0.0592.5 -4.5close+
Faital PRO 15FH520 v202536 +10.394 -0.06186.5 -30.68.8 -0.4596.8 -0.2close8 Ω vs 16 Ω: amp load changes · Xmax 8.8 mm < 9.25 mm: lower excursion-limited SPL+
Beyma 15LX6035 =0.346 -0.1215 -2.19 -0.2597.7 +0.7close8 Ω vs 16 Ω: amp load changes · Xmax 9 mm < 9.25 mm: lower excursion-limited SPL+
Volt RV450433 -20.349 -0.1217 -0.19.2 -0.0596.7 -0.3close8 Ω vs 16 Ω: amp load changes · Xmax 9.2 mm < 9.25 mm: lower excursion-limited SPL+
Oxygen JET 1832.9 -2.10.349 -0.1217 -0.110 +0.7596.7 -0.3close8 Ω vs 16 Ω: amp load changes+
SICA 15 S 3 PL 8 Ohms33 -20.38 -0.07230 +12.98 -1.2597.1 +0.1close8 Ω vs 16 Ω: amp load changes · Xmax 8 mm < 9.25 mm: lower excursion-limited SPL+
Faital PRO 15FH52036 +10.39 -0.06186.5 -30.68.75 -0.598 +1close8 Ω vs 16 Ω: amp load changes · Xmax 8.75 mm < 9.25 mm: lower excursion-limited SPL+
Sica 15 S 3 PL33 -20.38 -0.07230 +12.98 -1.2597.2 +0.2close8 Ω vs 16 Ω: amp load changes · Xmax 8 mm < 9.25 mm: lower excursion-limited SPL+

Compare the closest 3 against the 15FH500 →

Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.

Used in enclosures (0)

No enclosure in the catalog uses this driver yet.