← all drivers

Faital PRO 10PR320

10" · 16 Ω · 300 W · 95 dB · datasheet ↗

Thiele-Small parameters

Nominal size10"
Impedance16 Ω
Fs50 Hz
Qts0.38
Qes0.43
Qms3.3
Vas50.6 L
Sd347 cm²
Xmax7.27 mm
Re11.3 Ω
Mms33.6 g
Pe300 W
Sensitivity95 dB

Alignment hint

EBP116 · ported
Sealed Vb (Qtc ≈ 0.71)≈ 20.5 L

EBP > 100: favours a ported (bass-reflex) alignment.

Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.

Substitute candidates

DriverFs (Hz)QtsVas (L)Xmax (mm)Sens (dB)FitNotesCompare
Faital PRO 10FE30050 =0.39 +0.0149 -1.65.47 -1.894 -1close4 Ω vs 16 Ω: amp load changes · Xmax 5.47 mm < 7.27 mm: lower excursion-limited SPL+
LaVoce NBASS10-2052 +20.39 +0.0143.38 -7.226.6 -0.6795.5 +0.5close8 Ω vs 16 Ω: amp load changes · 150 W vs 300 W: lower power handling · Xmax 6.6 mm < 7.27 mm: lower excursion-limited SPL+
Beyma 10CX300/FE48 -20.38 =62.7 +12.16.75 -0.5294.1 -0.9close8 Ω vs 16 Ω: amp load changes · Xmax 6.75 mm < 7.27 mm: lower excursion-limited SPL+
Beyma 10"WRS 30052 +20.38 =42 -8.66 -1.2795 =close8 Ω vs 16 Ω: amp load changes · Xmax 6 mm < 7.27 mm: lower excursion-limited SPL+
Faital PRO 10PR320 16 Ohms50 =0.38 =44.1 -6.56.6 -0.6791.6 -3.4closeXmax 6.6 mm < 7.27 mm: lower excursion-limited SPL+
Beyma 10CM/V252 +20.42 +0.0444 -6.66.5 -0.7795 =close8 Ω vs 16 Ω: amp load changes · Xmax 6.5 mm < 7.27 mm: lower excursion-limited SPL+
18 Sound 10NW75052 +20.36 -0.0238 -12.67.1 -0.1794 -1closeXmax 7.1 mm < 7.27 mm: lower excursion-limited SPL+
Beyma 10"WR30052 +20.35 -0.0342 -8.66 -1.2795 =close8 Ω vs 16 Ω: amp load changes · Xmax 6 mm < 7.27 mm: lower excursion-limited SPL+
Eminence BETA 10CX49 -10.38 =61.1 +10.55 -2.2794.3 -0.7usable8 Ω vs 16 Ω: amp load changes · Xmax 5 mm < 7.27 mm: lower excursion-limited SPL+
Beyma 10"G4045 -50.3 -0.0849 -1.67 -0.2795 =usable8 Ω vs 16 Ω: amp load changes · Xmax 7 mm < 7.27 mm: lower excursion-limited SPL+

Compare the closest 3 against the 10PR320 →

Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.

Used in enclosures (0)

No enclosure in the catalog uses this driver yet.