ERS HP30/150E-8
Thiele-Small parameters
| Nominal size | 12" |
|---|---|
| Impedance | 8 Ω |
| Fs | 60.4 Hz |
| Qts | 0.715 |
| Qes | 0.991 |
| Qms | 2.566 |
| Vas | 45.9 L |
| Sd | 452 cm² |
| Xmax | 2.8 mm |
| Re | 6.1 Ω |
| Bl | 10.1 T·m |
| Mms | 43.3 g |
| Pe | 150 W |
| Sensitivity | 93.2 dB |
Alignment hint
| EBP | 61 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | Qts too high |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Europsonic TS30/600PRO-8 vp | 60.8 +0.4 | 0.717 = | 36.9 -9 | 4 +1.2 | 93.2 = | close | + | |
| Fane 12-100TC | 56 -4.4 | 0.779 +0.06 | 56.1 +10.2 | 2.5 -0.3 | 93.5 +0.3 | usable | 100 W vs 150 W: lower power handling · Xmax 2.5 mm < 2.8 mm: lower excursion-limited SPL | + |
| Siare 31TE vp | 53.4 -7 | 0.746 +0.03 | 62 +16.1 | 4.1 +1.3 | 93.8 +0.6 | usable | + | |
| SICA 12 D 1.5 CS 8 Ohms | 62 +1.6 | 0.748 +0.03 | 63.5 +17.6 | 2.7 -0.1 | 96.8 +3.6 | usable | 100 W vs 150 W: lower power handling · Xmax 2.7 mm < 2.8 mm: lower excursion-limited SPL | + |
| Celestion F12-X200 | 75 +14.6 | 0.777 +0.06 | 47.3 +1.4 | 3 +0.2 | 97.1 +3.9 | usable | + | |
| Sica 12 D 1.5 CS | 62 +1.6 | 0.75 +0.04 | 63.5 +17.6 | 2.7 -0.1 | 96.9 +3.7 | usable | Xmax 2.7 mm < 2.8 mm: lower excursion-limited SPL | + |
| JBL 2142H | 72 +11.6 | 0.755 +0.04 | 45.3 -0.6 | 2.2 -0.6 | 96.5 +3.3 | usable | 100 W vs 150 W: lower power handling · Xmax 2.2 mm < 2.8 mm: lower excursion-limited SPL | + |
| HH Electronics DC100LW | 60 -0.4 | 0.56 -0.15 | 56.6 +10.7 | 3.2 +0.4 | 95.2 +2 | usable | 100 W vs 150 W: lower power handling | + |
| Celestion TF1230 | 59 -1.4 | 0.515 -0.2 | 51.25 +5.35 | 4.8 +2 | 94 +0.8 | usable | + | |
| Mercuriale PTR 306 M0 | 58 -2.4 | 0.808 +0.09 | 70.1 +24.2 | 3.9 +1.1 | 94.6 +1.4 | usable | + |
Compare the closest 3 against the HP30/150E-8 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.