American Bass DX 10
Thiele-Small parameters
| Nominal size | 10" |
|---|---|
| Impedance | 4 Ω |
| Fs | 36.1 Hz |
| Qts | 0.486 |
| Qes | 0.54 |
| Qms | 5 |
| Vas | 20.7 L |
| Sd | 299 cm² |
| Xmax | 12 mm |
| Re | 3.43 Ω |
| Bl | 13.731 T·m |
| Mms | 131 g |
| Pe | 250 W |
| Sensitivity | 84.4 dB |
Alignment hint
| EBP | 67 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 18.5 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| Hertz Audio HX 250 | 37 +0.9 | 0.44 -0.05 | 24 +3.3 | 14 +2 | 85.8 +1.4 | close | + | |
| Polk Audio MM100 | 35 -1.1 | 0.46 -0.03 | 22.1 +1.4 | 8.7 -3.3 | 84.7 +0.3 | close | Xmax 8.7 mm < 12 mm: lower excursion-limited SPL | + |
| Infinity KAPPA 100.9 | 33.8 -2.3 | 0.44 -0.05 | 18.05 -2.65 | 17.5 +5.5 | 83 -1.4 | usable | + | |
| Alpine SWR-10D2 | 31 -5.1 | 0.505 +0.02 | 18 -2.7 | 10 -2 | 85.1 +0.7 | usable | Xmax 10 mm < 12 mm: lower excursion-limited SPL | + |
| JL Audio 10W6V3-D4 | 30.1 -6 | 0.513 +0.03 | 23.3 +2.6 | 10.5 -1.5 | 83.6 -0.8 | usable | 8 Ω vs 4 Ω: amp load changes · Xmax 10.5 mm < 12 mm: lower excursion-limited SPL | + |
| Gladen RS-X 10 | 35.57 -0.53 | 0.46 -0.03 | 27.8 +7.1 | 10 -2 | 85.9 +1.5 | usable | Xmax 10 mm < 12 mm: lower excursion-limited SPL | + |
| JL Audio 10W3V3-2 | 33 -3.1 | 0.495 +0.01 | 32.17 +11.47 | 14 +2 | 85.37 +0.97 | usable | 2 Ω vs 4 Ω: amp load changes | + |
| JL Audio 10W3V3-4 | 31.5 -4.6 | 0.485 = | 32.23 +11.53 | 14 +2 | 84.87 +0.47 | usable | + | |
| hertz Hertz Audio MPS 250 S4 | 29 -7.1 | 0.476 -0.01 | 21.2 +0.5 | 8.2 -3.8 | 85.8 +1.4 | usable | Xmax 8.2 mm < 12 mm: lower excursion-limited SPL | + |
| American Bass SL 104 | 33.6 -2.5 | 0.52 +0.03 | 26.8 +6.1 | 8.5 -3.5 | 84.3 -0.1 | usable | Xmax 8.5 mm < 12 mm: lower excursion-limited SPL | + |
Compare the closest 3 against the DX 10 →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.