AE Speakers TD15S-4ohm
Thiele-Small parameters
| Nominal size | 15" |
|---|---|
| Impedance | 4 Ω |
| Fs | 22.8 Hz |
| Qts | 0.371 |
| Qes | 0.41 |
| Qms | 3.87 |
| Vas | 467 L |
| Sd | 855 cm² |
| Xmax | 7 mm |
| Re | 3.5 Ω |
| Bl | 11.4 T·m |
| Mms | 106.9 g |
| Pe | 250 W |
| Sensitivity | 96.9 dB |
Alignment hint
| EBP | 56 · flexible |
|---|---|
| Sealed Vb (Qtc ≈ 0.71) | ≈ 177.4 L |
EBP 50-100: works in either a sealed or ported alignment.
Rules of thumb from T/S parameters only. Verify against a real simulation before cutting wood.
Substitute candidates
| Driver | Fs (Hz) | Qts | Vas (L) | Xmax (mm) | Sens (dB) | Fit | Notes | Compare |
|---|---|---|---|---|---|---|---|---|
| AE Speakers TD15S-4 Ohms | 22.8 = | 0.371 = | 467 = | 7 = | 96.9 = | close | + | |
| AE Speakers TD15S | 22.8 = | 0.371 = | 467 = | 7 = | 95.1 -1.8 | close | 8 Ω vs 4 Ω: amp load changes | + |
| AE Speakers TD15X 8 Ohms | 23.2 +0.4 | 0.287 -0.08 | 467 = | 7 = | 96.3 -0.6 | close | 8 Ω vs 4 Ω: amp load changes | + |
| Davis 39GCA15 | 23.6 +0.8 | 0.33 -0.04 | 402 -65 | 7.5 +0.5 | 95.6 -1.3 | close | 8 Ω vs 4 Ω: amp load changes | + |
| Crites Speakers CW1526 V2017 | 26.3 +3.5 | 0.346 -0.03 | 437.2 -29.8 | 7.2 +0.2 | 99.1 +2.2 | close | 150 W vs 250 W: lower power handling | + |
| Davis 39GPA15 | 26.2 +3.4 | 0.338 -0.03 | 384 -83 | 7.5 +0.5 | 97 +0.1 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| JBL 2216ND-1 | 27.6 +4.8 | 0.357 -0.01 | 378.4 -88.6 | 9.5 +2.5 | 96.8 -0.1 | usable | 8 Ω vs 4 Ω: amp load changes | + |
| JBL GT 152 | 24 +1.2 | 0.393 +0.02 | 319 -148 | 7.6 +0.6 | 97.9 +1 | usable | + | |
| EMS B15EX-05.0V | 22 -0.8 | 0.374 = | 791 +324 | 7 = | 96.1 -0.8 | usable | 8 Ω vs 4 Ω: amp load changes · 100 W vs 250 W: lower power handling | + |
| Altec 927-8A | 22.9 +0.1 | 0.278 -0.09 | 496.1 +29.1 | 8.3 +1.3 | 95.1 -1.8 | usable | 8 Ω vs 4 Ω: amp load changes | + |
Compare the closest 3 against the TD15S-4ohm →
Ranked on parameter similarity only (Qts, Fs, Vas, Xmax, sensitivity). Same nominal size required. A hint, not a simulation, model the swap before cutting or buying.
Used in enclosures (0)
No enclosure in the catalog uses this driver yet.